Wires needed to hook up subs and amp
Make sure you wrap all your wire connections with electric tape to reduce wires connecting to other metal parts and shorting. Amplifier power measuremnt is watt rms.
This will guide you through the process of installing subwoofers to an aftermarket CD player or stock in your car. I have had my sub for a few years and recently I had a few things in my boot, as i went round a corner something fell and it pulled ripped one of my cables off my speaker picture below.
Make sure you always turn off your amp when you leave your car, it will overheat and drain your battery. With the converter you get a small box with 2 RCA's coming out and 4 speaker wires out the other.
This process will work with most stock stereos, and all aftermarket stereos. Run the remaining wire under the cars carpeting or through a wire channel, if there is one. Don't forget to test your rem wire before you assume it works. A way you can do this is pull up the carpet and scrape the metal until it is bare metal with no paint left on it. I've been installing subwoofers and amplifiers into my cars since I was a teenager.
This is especially true with newer cars domestic and foreign.
The remote turn-on wire can be even thinner, and it only needs to be long enough to reach your head unit from wherever you have chosen to locate your power amp.
They aren't very expensive any more.
Step 1: Parts
Set the subwoofer in the trunk of the car. Installing powerful subwoofers into an older vehicle puts a big strain upon the metal panels of the car, and the welds holding the panels together.
If it does make noise like from the engineadd a switch so you can turn it on or off. This can be a tricky step. If you're using an wire needed to hook up subs and amp market head unit, go to an electronics store's stereo department and ask for a wiring harness from your car to the after market head unit.
Also, if you connect the line out converter straight to the subs without an amp, they won't have enough power to function. Don't worry about it!
Introduction: Installing Subwoofers in a Car
The RMS is also the amount of power the amplifier can continuously put out without over heating. Not Helpful 4 Helpful 3.
This moisture causes the metalwork of the car to rust. There is a blue wire with a white stripe hanging out of the back of the deck known as the remote wire.
There are many different types of enclosures sealed, vented, bandpass, infinite baffle, etc. The sub cuts on and off at high volume when I use the auxiliary cord to phone.